Differences

This shows you the differences between two versions of the page.

--- twiddler_wrap_install [2022/11/01 16:22] – tony
+++ twiddler_wrap_install [2024/05/03 17:21] (current) – external edit 127.0.0.1
@@ Line 12: / Line 12: @@
 Insert each end of the the bent wire into a hole.
 {{ https://tgimages.s3.amazonaws.com/twiddler/wiki/wirewrapback-small.png }}
+==== Step 2 ====
+Insert the Twiddler into the bottom of the Wrap and leave the top of the Twiddler outside of the Wrap.
+{{ https://tgimages.s3.amazonaws.com/twiddler/wiki/insert-small.png }}
+==== Step 3 ====
+Pull back the Wrap from the end of the wire and Insert the wire into the groove.  Pulling back gets the Wrap out of the way and gives you an unobstructed view of what you are doing.
+{{ https://tgimages.s3.amazonaws.com/twiddler/wiki/scrunch-small.png }}
+==== Step 4 ====
+Line up the wire with the other groove and press it into the groove.  There will be a bit of a "click" sound when it gets over the plastic and into place.
+{{ https://tgimages.s3.amazonaws.com/twiddler/wiki/scrunchclick-small.png }}
+==== Step 5 ====
+Once the wire is in place, stretch the Wrap over the top of the Twiddler. Feed the strap up through the wire from the bottom, fold it back on itself and press the snap into place.
+{{ https://tgimages.s3.amazonaws.com/twiddler/wiki/strap-small.png }}

Twiddler